Roma Werso Solar, Дополнительная инструкция

Страница: 7 / 54

This is only possible if the programming of end limits (item 2) has successfully been completed!
Action/Function Signal
1
or
Move the roller shutter to the limit
which shall be adjusted. (upper /
lower end limit, max. position
where the slats can be rotated).
2 5s
Press the UP and DOWN button
simultaneously for approx. 5s when
the roller shutter is inactive.
The roller shutter moves up and
down for a short time.
3
or
Move the roller shutter to the
adjusted end limits by pressing the
UP or DOWN button.
4
2 s
New end limits will be stored by
pressing the STOP button for ap-
prox. 2s.
The roller shutter moves up and
down for a short time.
3.2 Adjust end limit(s) (if requested)
Action/Function Signal
1
2s
Press the PROG button of the pro-
grammed transmitter for approx. 2s
The roller shutter moves UP and
DOWN for a short time. Memory
function is active.
2
Press the PROG button of the
transmitter which is to be adapted
or cleared for a short time.
The roller shutter moves up and
down for a short time.
At the same time the new trans-
mitter address will be adapted
(max. 12 transmitters) or the
already adapted address will be
deleted.
3.1 Adapt / delete additional transmitters
Action/Function Signal
1
Move the roller shutter to the
intermediate position by pressing
the STOP button when the motor
is inactive.
2
5 s
The roller shutter is in the inter-
mediate position. To delete this
position press the STOP button for
approx. 5s.
The roller shutter moves UP and
DOWN for a short time.
3.4 Delete an intermediate position 3.3 Programming an intermediate position
The following intermediate positions are pre-programmed at the
factory:
- for WERSO Standard -> „ventilating“
- for WERSO with venetian blind function -> position where the
slats can be rotated
They can be adjusted as follows:
Action/Function Signal
1
or
Move the roller shutter to the
requested intermediate position
by pressing the UP or DOWN
button and stop the roller shut-
ter by pressing the STOP button.
2
5s
New intermediate position will
be stored by pressing the STOP
button for approx. 5s.
The roller shutter moves UP and
DOWN for a short time.
The intermediate position can be approached from every start
position. By pressing the STOP button, the roller shutter moves
to the adapted intermediate position.
4. Battery change
• The battery has to be changed every two to five
years.
• When installing a new battery, please note that
polarity has to be observed.
• The rechargeable battery can be partly discharged
and inoperable when despatched. Charging possi-
ble by using a charging device (optionally availa-
ble). The roller shutter will be ready-for-use
within a few minutes!
3. funky-additional programming (how to adapt and delete additional transmitters, how to adjust end limits,
intermediate position)
red lead = positive terminal
black lead = negative terminal