Continued…..
Note: Should any parts need replacing during routine maintenance
please consult your local Dealer for approved spare parts for your
scooter. Failure to do so may damage the scooter and void your
warranty.
Troubleshooting
Circuit Breaker
Your scooter is fitted with the latest in
electronic controls that are programmed
to
protect the electrical system from abnormal
overloads. Fitted for extra protection is a
circuit breaker. Should there be a situation
where your scooter stops for no apparent
reason please check that the circuit breaker
has not tripped. The circuit breaker is located
is located through a hole in the shroud
underneath the seat behind the seat post. Press
this button to reset the circuit breaker.
Note: Should the circuit breaker continue to trip turn off the scooter
immediately and consult your dealer.
Fuses
Inline 50 amp blade type fuses from the batteries protect any overload,
and a 15 amp fuse is located in the battery charger as extra protection.
Note: Should the fuses need replacing please contact your dealer
to ensure the correct sizes are fitted. Failure to do so could result
in permanent damage to the scooter’s electronics and possibly
cause a fire hazard. Failure to do this will void your warranty.
Check List
If you scooter fails to operate, please check the following:
•
The unit is switched on.
•
All plugs and connectors are firmly fixed.
•
Battery level shows full charge.
•
Freewheeling device is in the drive position (lever down).
•
Circuit breaker has not tripped
If the freewheel device has been operated with the scooter left switched on,
the scooter will bleep continually and not operate until the ignition key has
been switched off then on again.
Please consult your dealer if your scooter does not run after checking these
points.
Circuit Breaker Reset
Page 12
