Set-up and Operation
Assembly
Your
Dalerise
chair should be delivered in one box, this contains the base
frame and the back assembly. Take care when opening the box as sharp
objects may damage the upholstery.
Take the backrest assembly and carefully locate both the base unit brackets
inside the back unit brackets. Push the backrest downwards until the base unit
brackets are fully located inside the back unit brackets.
Power Connection
Transformer Set-up
Your transformer will need three 9-volt PP3 type batteries
(not supplied) for emergency purposes, which will
lower
the chair in the event of power failure. Remove the two
screws holding the battery-retaining clip on the underside
of the transformer and connect the batteries. Locate the
batteries in the slots and refit the battery-retaining clip.
Note: The emergency batteries will only lower the chair
once. They must be replaced after being used.
Connecting the Power
At the back of the chair you will see a small lead with a male
plug (Y in the picture). Take this lead and connect the female
plug (X in picture) from the transformer and push together
firmly (a positive ‘click’ will be felt/heard).
Should the male/female plug not engage properly the chair will
not operate due to an insufficient power supply. (If this
happens the three batteries under the transformer should be changed
immediately, as emergency use will completely drain the power.)
Ensure the back of the chair is positioned at least 40cm away from the wall.
Plug the transformer pack into the mains supply and turn on the power. Before
sitting in the chair, check that there is sufficient clearance for the backrest and
foot supports by fully reclining the chair.
Base Unit Bracket
Back Unit Bracket
View Underneath
4