Manual No. 4801-5156 Rev 4-08
RollSeal SC-325 & SC-650
Page 3 of 44
1. Warnings
(Avertissements)
WARNING!
Disconnect All Power Sources Before Installing this Equipment. Failure to
Disconnect Power Source Can Result in Property Damage, Serious Injury or
Death!
WARNING!
The installer is responsible for complying with all relevant regulations, such as
national wiring regulations and accident prevention regulations. Particular
attention must be given to the cross-sectional areas of conductors, the selection
of fuses or other protection, and protective earth/ground connections!
WARNING!
The voltages in the power cables and certain parts of the drive can result in
death. Whenever the drive has been used it must be isolated and disconnected
for 5 minutes before any work commences.
WARNING!
Drives are intended as components for incorporation into electrical control
systems or machines. It is the responsibility of the installer to ensure that the
drive is installed safely and in accordance with any regulations which apply to the
end product at the place of use, for example regarding safety or electromagnetic
compatibility. To ensure mechanical safety, additional safety devices such as
electro-mechanical interlocks may be required!
DANGER!
Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, and/or service this
equipment. Read and understand this manual in its entirety before proceeding.
Failure to observe this precaution could result in severe bodily injury or loss of
life.
!
!
!
!
!