INTRODUCTION
Thank you for purchasing the ROLLS RPL108 Power Conditioner and
Rack Light. Please read the following owners manual carefully to get the
most from this product.
FEATURES:
• Eight switched AC outlets
• Two light modules
Dimmer to adjust light modules brightness
Adjustable swivel and pull-out positioning
The RPL108 protects your delicate electronic equipment by combining a
high voltage varistor (MOV) surge and transient suppressor with an RFI/
EMI interference filter. The fast-acting suppression circuit responds in less
than a nanosecond, clamping transient voltages to safe levels. The filter
works to prevent noise from fluorescent lights, certain dimmers, radio
transmitters, and similar sources of "electronic pollution" from contaminat-
ing the AC line and from there, leaking into sensitive audio, video, or
computer circuits.
OPERATION
MAXIMUM LOAD
The eight circuit breaker protected outlets are rated at 15 amps, which is
equivalent to 1800 watts at 120 volts. If the total load on the RPL108
(combining all outlets) exceeds 15 amps, the circuit breaker will trip,
cutting off power to your rack. If this happens, reduce the load by unplug-
ging one or more units from the RPL108. Then push the circuit breaker
button in to reset it.
LAMPS
The RPL108 lamps pull out easily and may be aimed to provide the best
illumination for your equipment. Each lamp is supplied with a 7 watt night-
light bulb. Replacements are readily available at most hardware stores, or
wherever household lightbulbs are sold.
BULB REPLACEMENT
Bulbs are easily replaced without removing the unit from the rack. Simply
unscrew the cap on the end of each light tube, remove the old bulb and
replace.
CAUTION - BURN WARNING:
The caps and light tubes become hot
during normal operation. Avoid burning your fingers by allowing the cap to
cool completely before unscrewing it.
Do not push the tubes in while the caps are unscrewed. If you find that the
heat from the tubes is excessive, reduce the setting of the Dimmer
control, or substitute a 4-Watt bulb.
POWER SWITCHES
The RPL108 has a master POWER switch for the rear outlets as well as
the lights. This switch glows when the unit is on.
To turn on the lamps, switch the RACK LIGHTS switch to the ON position,
and adjust the DIMMER control for the desired brightness. The lights do
not turn off automatically when the tubes are pushed in, so be sure to
switch the RACK LIGHTS switch to the OFF position before pushing in
the tubes.
O N
O F F
R E A R O U T P U T S
P O W E R
R E S E T
P U L L
P U L L
R A C K L I G H T S
D I M M E R
O N
O F F
M I N
M A X
R P L 1 0 8
P O W E R C O N D I T I O N E R A N D R A C K L I G H T
1 8 0 0 W A T T S M A X
M A X I M U M L O A D : S W I T C H E D O U T L E T S 1 2 0 V A C , 1 5 A , 1 8 0 0 W A T T S
A C I N
1 2 0 V A C , 1 5 A , 6 0 H z
WARNING:
DO NOT EXPOSE THIS EQUIPMENT TO RAIN
OR MOISTURE.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE BACK.
NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
RISQUE DE CHOC - NE PAS ENLEVER
M O D E L R P L 1 0 8
A V I S : R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R
