17
RolliBot RolliCOOL 208-20 Portable AC User Manual
Using the Upper & Lower Drainage Openings
1. Turn off and unplug the unit, then move it to a
suitable location for drainage. Set a container near
the unit for water runoff if needed, then place the
end of the drainage pipe in the container.
2. Remove the cap from the opening and connect
the drainage pipe to the unit via the opening.
If the drainage pipe is too stiff and/or cannot be attached, try
soaking the end in hot water to soften it first.
3. Allow the water to drain.
After draining is complete, it is recommended to turn the unit on and
run it in Fan Mode at the lowest speed for at least two hours in order to ensure
the Drainage Pipe dries inside.
4. Detach the pipe and reinstall the cap.
Section 7. Storage
Store your RolliCool 208-20 in a dry, indoor environment. Properly storing your RolliCool will
help improve performance and battery life expectancy.
Step 1.
Turn the AC unit off.
Step 2.
Remove the exhaust pipe and window kit as needed for storage with the unit.
Step 3.
Drain the unit of any water and ensure all parts are completely dry.
Step 4.
Turn the unit on and run it in fan mode at the lowest speed for at least two hours in
order to ensure the inner reservoir is dried inside.
Step 5.
Turn off the unit and install the power cord’s plug into its fixture on the back of the unit.
Step 6.
Remove the remote batteries and store separately.
• Always turn the unit off before transporting or storing.
• Cover the unit to protect it from dust. Do not store in a dusty environment. As with all electronic devices, dust may cause
damage over time.
• Store the unit indoors at a dry and stable temperature. Do not store in an unheated garage, shed, or other locations with
extreme temperature fluctuations.
