6
Rollerdor RD20X2ANSA Control Box, Edition 2022/1
Handsets that come supplied with the receiver
box are normally programmed in and work in a
sequential operation but if any extra handsets need
programming please follow instructions below.
1
Press and hold the operation button on
receiver box next to the RED LED for roughly
5 seconds and release when the RED LED
goes out
(fig.13 & fig.14)
2
The RED LED will flash once to say it
is programming mode: With the new
unprogrammed handset in hand, press and
release the top button
(fig.15)
and the red
LED will flash once again, repeat for every
handset to be added.
3
After programming all desired handsets
wait 30 seconds for the RED LED to come
back on solid and the door is out of
programming mode and ready to use, test
handset to check and repeat the process if
programming hasn’t worked.
SEQUENTIAL OPERATION
1
Turn mains power off.
2
Move dip switch number 6 in the up position
(fig.16)
.
3
Turn mains power on, the YELLOW LED “set
radio” will light up for 5 seconds.
4
Turn mains power off, Move dip switch number
6 back down, turn mains power on. All handsets
are wiped.
CLEARING MEMORY OF REMOTE
CONTROL HANDSETS
fig.16
3. PROGRAMMING OF REMOTE
CONTROL HANDSETS
fig.14
fig.15
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
