Page� 6
EXTREME Wire Guide Installation Manual | v 3.0
2020 © Copyright All Rights Reserved Rollease Acmeda
VERTICAL DIMENSIONS
STEP 1 - CHECK VERTICAL INSTALLATION
DIMENSIONS AT EACH END
STEP 2 - CHECK VERTICAL INSTALLATION
DIMENSIONS AT EACH END
SECTION 2
| PREPARING INSTALLATION SPACE
HORIZONTAL DIMENSIONS
STEP 1 - CHECK HORIZONTAL INSTALLATION
DIMENSIONS AT TOP & BOTTOM
STEP 2 - END CAP INSTALLATION FLOAT
NOTE:
•
Avoid installing Extreme in windy conditions�
•
Check for any obstructions that may interfere with
installation�
•
This may mean the installer needs to take steps
to prepare the space prior to commencement of
installation�
Check if top of installation space is level�
H2
H1
H1
H2
For Top Fix systems, consider corrective options prior to
commencing installation to ensure the blind can be installed
level�
W1
W2
W1
W2
If difference between W1 and W2 is greater than 5mm
(0�197"), pack out installation space as required�
If W1 and W2 are within 5mm (0�197") proceed with
installation�
1
2
END CAP FLOAT
X
± 5mm (0�20")
Determine what the dimension of x is on each side�
X+
X+
X-
X-
If adjustment range is adequate proceed with installation, if not
consider further options for squaring out the installation space
(such as packing or other)�
