13
| Automate
™
Installation Instructions | DC Power Distribution Panel
ROLLEASE ACMEDA
If motors powered by the DC Power Distribution Panel are to be used
with the
Automate Pulse 2 Hub and Application
, the output voltage of the
Distribution Panel
MUST
be adjusted to allow for proper communication
between the Hub and Motor.
If motors are connected to the Automate Pulse 2 Hub, it is RECOMMENDED the motors of the same type (MTDCRF28/25 or
MTDCRF45/35) are used in the installation. It is NOT recommended to power motors of differing types from one DC Power
Distribution Panel.
Output Voltage (11.4VDC to 15VDC) of the DC Power Distribution Panel
can be adjusted via the Trim-Pot located on the converter within the
Distribution Panel.
NOTE: Adjusted Output voltage is applicable to all 18 Channels.
WARNING: DANGEROUS LIVE VOLTAGE.
DO NOT ATTEMPT UNLESS QUALIFIED TO OPERATE AC MAINS VOLTAGE DEVICES.
Output Voltage of the Distribution Panel must
be monitored as it is adjusted. This involves
probing the output of the Panel while it is live.
Monitor output voltage using a
multimeter
,
and adjust potentiometer using an
appropriately sized Philips Head screwdriver.
When motors are to be controlled via the
Automate Pulse 2 Hub, the maximum
allowable voltages for each motor is as shown:
A.1 PULSE 2.0 HUB - ADDITIONAL INSTALLATION/SET UP INSTRUCTIONS
A.2 ADJUSTMENT PROCEDURE
MOTOR
12V
MTDCRF35-3
MTDCRFQ45-3
MTDCRF45-10
MTDCRF-CL-0.6-50
MTDCRF-TILT-1
14V
MTDCRF25-1.1
MTDCRF28-2
MT01-3001-069001
IMPORTANT!
IMPORTANT!
IMPORTANT!
