6
| Automate
™
Programming Instructions | Motion Sensor
ROLLEASE ACMEDA
1
STATIC TITLE
When battery voltage is lower than 2.3 V, it beeps every 5 seconds.
Adjust sensitivity accordingly. The detected vibration range is 3G. (1G = 9.8 m/s
2
)
High sensitivity could cause awning to react under slight wind.
If the disc magnet is dislodged, the vibration detection and low battery alarm functions are invalid.
•
Dial Set to 0: Sensor is in pairing mode. Use P2 to pair to motor with existing pre-paired remote.
•
Dial Set to 1-9: In Active mode, sensitivity, Highest - Lowest.
•
Dial set to 5: Move motor to upper limit/Motion Sensor in Active mode.
•
Dial set to 9: Move motor to bottom limit/ Motion Sensor in Inactive mode.
1. Set Sensitivity Dial to zero
2. Pair or unpair a motor to the sensor
using a pre-paired remote
3.1 SENSITIVITY DIAL / P2 OPERATION
3.2 PAIRING TO MOTION SENSOR
A
= Existing controller or channel (to keep)
B
= Motion Sensor to add or remove
Press
P2
on
controller A.
Press
P2
on
controller A.
Press
P2
on
Motion Sensor
B to add or
remove.
Response
Response
Response
NOTE:
•
The ARC Motion Sensor can only be connected and paired to External Motors (15Nm and above).
•
After the sensor is paired to a motor, it can independently drive the motor without the remote.
3 FUNCTION
