Roll-X 327/175 GO, Руководство по установке, Страница: 19 / 26

18
3.9 Mount the bed end covers on both sides of the table.Use 8pcs of the black self - drilling screws and 4pcs M4x20 Hex screw.
Put pressure on the top of the bed end covers (see the red arrows) when mounting the self - drilling screws.
4.0 Place the cutting mat roll on one of the flatbed sides. Roll it out as even across the flatbed as possible.
Use the glide beam roller to remove air between the cutting mat and the glass. If needed, lift up half the mat by hand and
roll it out with pressure form the glide beam roller. Do the same proceedure on the other side.
When the cutting mat is in position and air pockets has been removed, trim the mat along the sides if the working area (glass
area).
We strongly recomend to use the EXC cutting device to this procedure).