Mounting on the Hi-Hat Stand
8
(4) Connecting to a Sound Module
* To prevent malfunction and equipment failure,
always turn down the volume, and turn off all the
units before making any connections.
1.
Connect the VH-13’s TRIGGER OUTPUT jack to
the sound module’s TRIGGER INPUT HI-HAT jack,
and the VH-13’s CONTROL OUTPUT jack to the
sound module’s HH CTRL jack.
TRIGGER
OUTPUT
jack
CONTROL
OUTPUT
jack
to
TRIGGER INPUT
HI-HAT jack
to
HH CTRL jack
* Use stereo (TRS) cables to make the connections.
If monaural cables are used, edge shots cannot be
supported.
2.
Secure the cables in place with the cable tie,
while leaving some slack in the cables.
Leave some
slack in the
cables
Wind the
cable tie
once
Tighten it
not to slip
Turn back to
fix the cables
(5) Adjusting the Sound Module
When using the VH-13, you will need to make the
settings for the sound module.
When Using with the TD-30
1.
Press the TD-30’s [TRIGGER] button.
2.
Press the [F3 (HI-HAT)] button.
The TRIGGER HI-HAT screen will appear.
3.
Set the Hi-Hat Type to “VH13.”
4.
Loosen the clutch screw of the top hi-hat and let
it sit on the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
clutch screw
5.
Hold down the TD-30’s [KIT] button and press
the [TRIGGER] button.
The “VH offset” parameter is set automatically (approx. 3
seconds).
The [TRIGGER] button stops flashing and remains lit.
For details, refer to the TD-30 owner’s manual.
