Roland VersaUV LEC2-300, Руководство по установке

Страница: 27 / 58

25
2. Assembly and Ink Filling
2.Installation
Step 1: Assemble the Stand and Mount the Machine on the Stand
WARNING
Perform this task with all power switches left switched off.
Failure to observe this instruction may cause the machine to move suddenly,
resulting in injury.
CAUTION
Unloading and emplacement are operations that must be performed by 6 persons
or more.
Tasks that require undue effort when performed by a small number of persons may
result in physical injury. Also, if dropped, such items may cause injury.
Procedure
A
Attach the stand stay to the stand legs.
Position the stand legs so that their U-shaped brackets face the inside, and then tighten the bolts
securely (eight locations in total) in the order shown below. Loose bolts may cause the stand to wobble.
Temporarily tighten the bolts in the two upper locations. (On the left and right sides for
a total of four locations.)
Temporarily tighten the bolts in the two locations on the sides. (On the left and right
sides for a total of four locations.)
Fully tighten the bolts in the two upper locations. (On the left and right sides for a total
of four locations.)
Fully tighten the bolts in the two locations on the sides. (On the left and right sides for a
total of four locations.)
Tighten temporarily
→ tighten fully
Bolts: 8
Washers: 4
Stand leg
Stand stay
Stand leg
Stand stay
Make this gap
uniform. Align these parts
so they are parallel.
Side
Top
Bolt
Bolt
Position the stand legs
so that the U-shaped
brackets face the inside.
Stand leg
Stand stay
Hexagonal
wrench
Hexagonal
wrench
Washer
Washer
Place the stand stay on the stand legs as shown in the following figure.