Roland VersaStudio BT-12, Руководство по эксплуатации

Страница: 192 / 234

190
9. Troubleshooting
DYX035
1 1
1. Sensor
2.
Press the [Start] key.
Printing starts.
If printing does not start, repeat Steps 1 and 2 until the height becomes appropriate for
printing.
Adjusting the height of the tray automatically
• Remove the garment from the tray before performing auto adjustment. Do not perform
auto adjustment while the garment is on the tray.
• When you perform auto adjustment, the height of the tray is adjusted appropriately
according to the tray that is set. Perform auto adjustment again every time a different tray
is set.
• When you perform auto adjustment, the height of the tray is adjusted so it is suitable for
loading thin garments, such as T‐shirts. When loading thick garments in the tray, finetune
the height of the tray using the [Adjust Height ] key after sending the print job. For
details, see page 189 "
Adjusting the Height of the Tray ".
When printing starts, the machine adjusts the height of the tray according to the height value
specified in the [Maintenance] menu. If the printed image is blurry or there is dust stuck to it, or
the height of the tray may not be adjusted appropriately, adjust the height of the tray using the
[Maintenance] menu. This section explains how to adjust the height of the tray automatically
using the [Maintenance] menu. For details about adjust the height of the tray manually using the
[Maintenance] menu, see page 191 "
Adjusting the height of the tray manually ".
1.
Load the tray without a garment on it.
2.
Press the [ /Menu] key.
3.
Press the [ ] or [ /Menu] key to display [Maintenance], and then press the
[#Enter] key.
4.
Press the [ ] or [ /Menu] key to display [Height Adjust], and then press the
[#Enter] key.
5.
Press the [ ] or [ /Menu] key to display [Auto Adjust], and then press the
[#Enter] key.