4
(1) Assembling the Bottom Cymbal
1.
Remove the clutch included with the hi-hat stand
from the cymbal rod.
* The clutch included with the hi-hat stand will not be used.
* It is not necessary to remove the felt (or rubber) pad on the hi-hat
stand used for supporting the bottom cymbal.
2.
Confirm that the cymbal rod is firmly secured.
* For instructions on tightening the cymbal rod, refer to the owner’s
manual for your cymbal stand.
Cymbal Rod
* Looseness or play in the cymbal rod can make the top cymbal
unstable, causing it to shake or turn, and prevent proper
functioning.
3.
Place the bottom cymbal on the hi-hat stand with
the cymbal rod passing through the bottom cymbal
hole.
If your unit allows the angle of the cymbal receiver to be adjusted,
adjust it to the horizontal position. Malfunction may occur if this is
tilted.
At this point, position the
7
mark so it’s facing the performer.
Hi-hat stand felt (or rubber)
cymbal pad
The link jacks A/B should be on the left and right sides from the
player’s perspective at this time.
Link jack B
Link jack A
4.
Select the spacer that matches the diameter of the
pipe at the top of the hi-hat stand.
There are three spacers to match different pipe diameters.
L:
25.4 mm (1”)
M:
22.2 mm (7/8”)
S:
19.1 mm (3/4”)
Without spacer: 28.6 mm
5.
Remove the clamp bolt, then fit the spacer and the
clamp so they are nested together.
S
S
L
L
M
M
S
S
L
None
M
S
25.4 mm
(1”)
28.6 mm
(1-1/8”)
22.2 mm
(7/8”)
19.1 mm
(3/4”)
Installing the Cymbals onto the Hi-Hat Stand
Precautions regarding placement of this unit on a stand
Be sure to follow the instructions in the Owner’s Manual carefully
when placing this unit on a stand (p. 4–p. 7).
If it is not set up properly, you risk creating an unstable situation
which could lead to the unit falling or the stand toppling, and
may result in injury.
