1
Speaker Stand
SS-115B Owner’s Manual
Thank you for choosing the SS-115B Roland Speaker Stand.
When installed in combination with speakers other than one listed in “Applicable speaker models” under “Specifications,” Roland makes
no assurance as to the stability thereof. Before attempting such use, be sure to check carefully to ensure that stable installation and
continued stability during use are possible.
Main Futures
• Equipped with a height-adjustment stopper, making it easy to change the height of the stand.
• Allows mounting of speakers without brackets.
• You can freely set the opening angle of the tripod, so stability is excellent.
• The lightweight yet rugged aluminum construction promises outstanding mobility.
Attachment Procedure
1.
Loosen knob bolt #1 and open the tripod. After opening the tripod,
tighten the knob bolt again.
* Be careful not to pinch your fingers.
* The distance between lower ends of the tripod should be 1200 mm as
shown in figures on the next page. If the tripod is not opened wide
enough, the stand may be unstable.
* Make sure that the lower end of stand #1 does not touch the floor.
2.
Loosen knob bolt #2 and make stand #2 longer.
3.
Set up stand #2 at the required height and insert the stopper into the
hole in stand #2. (refer to figure 2)
* Be careful not to pinch your fingers.
* Use the SS-115B only with the stopper inserted into stand #2.
4.
Tighten knob bolt #2.
5.
Fit the hole on the speaker system onto stand #2.
* Be careful not to pinch your fingers.
Installation Cautions
• The distance between lower ends of the tripod should be
1200 mm as shown in figures on the next page.
• For safety and stability, total height of the SS-115B and a
speaker system must be 1.8 m or less.
• Stability may be affected when the stand is set up on carpeting
or any other soft surface. When using the stand on such
surfaces, please give ample attention to the angle of the tripod.
• Make sure that the tripod is wide enough and stand #2 is not
too high to ensure that the stand is stable when a heavy model
is placed on the stand.
• Tighten knob bolts firmly.
Specifications
• Applicable speaker models: SST-151, KC-100, KC-300 (with no brackets)
RDS-170, DA-800, DA-1500, SRS-80, SRS-120 (with a bracket)
* For models not listed above, refer to the owner's manual of each model.
• Max load:
294N (30 kg/66 lbs 3 oz)
• Weight:
2.6 kg/5 lbs 12 oz
• Finish:
Black alumite (aluminum)
• Dimensions:
198 (W) x 121 (D) x 1105 (H) mm 7-13/16 (W) x 4-13/16 (D) x 43-9/16 (H) inches
(when attached the included bracket and folded most compactly)
• Accessories
Bracket, Owner’s Manual, Screws (5 x 50 mm) x 4, Flat washers (5 mm) x 4
* In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice.
Copyright © 1999 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Before using this unit, carefully read the section entitled: “USING THE UNIT SAFELY” (p. 2). This section provides
important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have
gained a good grasp of every feature provided by your new unit, this manual should be read in its entirety. The manual
should be saved and kept on hand as a convenient reference.
Knob bolt #1
Knob bolt #2
Stand #1
Tripod
Stopper
Stand #2
figure 1
figure 2