2
SI-AD4 / SO-DA4 Installation Manual
1
Remove the two screws from each module (SI-AD4 or SO-DA4) installed in the
S-4000S.
2
Extract the module from the S-4000S.
1
Load the modules (SI-AD4 or SO-DA4) into the S-4000S.
2
Align the module's circuit board with the slot in the S-4000S, and insert
slowly.
3
Press in the module firmly until you feel resistance.
4
Secure the module in place using the two screws removed when detaching
the module.
Installing an SI-AD4/SO-DA4
Installing an SI-AD4/SO-DA4
The module shown in the
figure is the SO-DA4. The
removal procedures for the
SI-AD4 and SO-DA4 are the
same.
Extraction of the SI-AD4 or
SO-DA4 may be accomplished
more easily by inserting an
XLR plug into a connector on
the module, then pulling out
the module while gripping the
plug.
Refer to the Service Notes issued by Roland and perform the operational checks
necessary to ensure that each module has been installed correctly.
SI-AD4_r_e.fm 2 ページ ２００５年１２月２２日 木曜日 午後５時１７分