9
Using the S-240P
Use the following procedure to remove the DC OUTPUT plug.
1.
Pull and continue to hold out the DC OUTPUT plug’s lock switch while rotating the plug to the left
(counterclockwise).
2.
Disconnect the DC OUTPUT plug from the EXT. POWER DC INPUT on the S-4000S or S-4000H’s rear
panel.
1.
Connect the system components as described previously.
2.
Connect the S-240P’s EXT. DC OUTPUT plug to the EXT. DC INPUT connector on the S-4000 Series
device.
For instructions, refer to “Connecting the Backup Power Supply to the S-4000” (p. 8).
3.
Turn on the front panel power switches on the S-4000 series unit so that the POWER indicator lights.
4.
Turn on the front panel power switches on the S-240P unit so that the POWER indicator lights.
Disconnecting the Backup Power Supply
Powering Up/System Status Indicators
Powering Up
The S-240P unit is equipped with protection circuits. A brief interval (a few seconds) after power up is required
before the unit will operate normally.
S-240P_e.book 9 ページ ２００７年５月２３日 水曜日 午後２時５２分
