6
Using the S-4000 System
The S-4000H can used in a free standing configuration, or rack-mounted using the
installed rack-mount brackets.
Recessed Rack-Mounting
If desired, the rack-mount brackets on the S-4000H units can be re-installed so that the
units’ face plates are recessed when mounted in a rack. This can be useful for
protecting the front panel connections in high-traffic installations.
Use the following procedure to remove and reinstall the S-4000H’s rack-mount
brackets for recessed rack-mounting.
1.
Turn off the power on all equipment and disconnect all cables from the S-4000H
unit.
2.
Remove only the screws shown in the following diagram (6 screws on each
side, 12 screws total), and detach the rack-mount brackets from the sides of
the unit as shown.
3.
Using the screws you removed in Step 2, reinstall the rack-mount brackets as
shown.
Installation Notes
Whatever method you choose,
be sure to provide adequate air
flow around the units, and be
sure not block the intake and
exhaust vents. Failure to do so
will result in the units
overheating, causing
automatic shutdown and
possible damage.
Keep any screws and REAC
cover you may remove and the
included screws and REAC
cover in a safe place out of
children's reach, so there is no
chance of them being
swallowed accidentally.
S-4000H_e_book 6 ページ ２００５年１１月２１日 月曜日 午後４時４７分
