5
When adjusting, use the included drum key.
1
Loosen the tuning bolts until a slight gap is produced.
2
Tighten all tuning bolts by fingers, as tightly as you can.
fig.
3
Using the drum key, turn the tuning bolts two full revolutions each, thus
tightening them.
Tighten each tuning bolt one by one, observing the numerical order shown in the
figure.
fig.
By using the TD-20/12 as the sound module, you can produce changes in the sound
depending on the position on the head that is struck. For accurate detection of the
point where the head is struck, adjust the tension so that it is completely uniform
throughout the head.
Adjusting the Head
Adjusting the Head Tension
Positional Sensing with the TD-20/12
On the PD-125/105, adjusting
the head tension affects only
the head response, and not the
pitch of the sound, as it would
on an acoustic drum. To adjust
the pitch, edit the sound
parameters of the TD-20/TD-
12. For details refer to the
respective owner's manual.
Head tension may change over
a period of time, so readjust
when necessary.
Heads MUST BE TUNED BEFORE PLAYING.
Like with an acoustic drum, accurate and equal head tension is needed for correct
triggering response.
Tuning bolt
Washer
Hoop
Slight gap
1
3
4
2
5
6
HEAD MADE BY REMO U.S.A.
PD-125_105_e 5 ページ ２００６年９月２８日 木曜日 午後３時５３分
