Roland MODELA Pro MDX-500, Руководство пользователя

Страница: 39 / 72

37
Part 1 Setting Up
Rotate the dial in the direction of the arrow shown in the
figure to extend the cutter to the engraving depth (cutting-
in amount).
Move the cutter out just enough for the necessary
engraving depth.
The lines printed on the dial indicate 0.0254 mm (0.001
in.) for each mark. For instance, to set a cutting depth of
0.5 mm (0.0197 in.), rotate an 20 mark portion.
9
Bottom of the head
Raise the spindle with the tool up (+Z) key.
* When attempting to move the head, first close the
spindle cover.
8
Use a program or the operation panel to set the tool-down position. Set this at a cutting-in amount about 2 to 3 mm deeper than
the cutting-in amount set using the micrometer dial (the actual cutting-in amount).
Setting a cutting-in amount that corresponds to the difference in height between the highest and lowest locations on the
workpiece allows the tip of the depth regulator nose to be constantly pressed against the surface of the workpiece and enables
engraving at a uniform depth.
* The spindle stroke due to the nut is approximately 5 mm (3/16 in.).
It is not possible to absorb differences in height greater than 5 mm (3/16 in.).
10
Engraving depth
Workpiece
Difference in height between
the highest and lowest locations
Spindle stroke