3. Basic Operations
56
Adjusting vacuuming areas
The relation between the vacuum valves and vacuuming areas is shown below. Switch the vacuum valves to
adjust the vacuuming areas to match the size of the media to be used.
1.
Valve is closed. (Vacuuming of the selected area is disabled.)
2.
Valve is open.
Setting positioning pins
The positioning pins for aligning the media straight are built into the table. The positioning pins are set when
the positioning pin switch on the front of the machine is turned on. You can use them as a guide. An air
compressor is required to use the positioning pins. For details, contact your authorized Roland DG
Corporation representative.
The locations of the positioning pins are shown below. Positioning pins are built into the table with three in
the X direction and Y direction respectively.
Содержание IU-1000F
