Roland iModela iM-01, Руководство пользователя

Страница: 11 / 73

10
Chapter 1 Basic Operation
Selecting the Command Set
About the Command Sets
You can select one of the following command sets on this machine.

RML-1
Select this command set when you want to use the software that was included with this machine.

NC Code
Select this command set when you want to use NC codes. For details on NC codes, see page 63, "NC Code
Specifications" and the "NC Code Reference Manual" that was included with this machine.

RML-1/NC Code
Select this option to enable the machine to receive cutting programs that use the RML-1 or NC code com-
mand sets.
Selecting the Command Set
Use the iModela Controller's Confirm dialog box to select the command set. Select the appropriate command
mode to match the application software to be used.
If a command that is sent to the machine is different
from the command set selected on the iModela Controller, an error occurs and the machine will not be
able to carry out the cutting command.

Factory default setting: RML-1
This is enabled when you select "NC Code" or "RML-1/NC Code."
For details on the NC code settings, see page 30, "NC Code Set-
ting."
The selected command
set is displayed here.