Connections
6
Turning On the Power
Be sure to observe the following order when connecting devices and switching on the power to your equipment. If
you turn on equipment in the wrong order, you risk causing malfunction or equipment failure.
Connect the GK-Compatible Guitar
g
(Connect the AC Adaptor)
g
Connect the Amp
g
Turn On Amp Power
*
This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the unit on is required before it will operate
normally.
*
Before turning the unit on/off, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound
when switching the unit on/off. However, this is normal and does not indicate a malfunction.
Application Examples
Connecting another effects unit following the GR-D
Guitar Amp
Recorder or Mixer
Effect Device
Effect Device
GK-compatible
guitar
GK-compatible
guitar
Using in combination with other effect devices (send/return)
OUTPUT
INPUT
When connecting to
the recorder or mixer,
set the [SELECT] switch
to “LINE”
*
When connection cables with resistors are used, the volume level of equipment connected to the inputs (MIX/GUITAR INPUT jacks) may be low.
If this happens, use connection cables that do not contain resistors.
Normal pickup signals of the GK-compatible
guitar are output. By connecting another effects
unit and returning its signal to the MIX INPUT
jacks, you can use the unit for send/return
applications.
If the sound of the
connected effects
unit is unnaturally
distorted, reduce
the volume of the
effects unit.