7
IDENTIFYING THE VERSION NUMBER
1.Set the each potentiometers as follows.
2. Turn the power on, while holding down the [TAP] button.
The software program version will be displayed on the
display and it will blink few times.
Next, DJ-2000 get back to normal mode automatically.
This test mode is for DSP EFFECT Board.
●
Entering test mode
Set the each potentiometers as follows.
Turn the power on, while holding down the[TAP]
button and [FREQ RANGE] button.
DJ-2000 will enter the test mode and the software
program version will be displayed on the display and it
will blink few times.
At the same time, DRAM check runs automatically. If the
function are normal, LED TEST stars automatically. (It
takes about 3 sec.)
1. DRAM TEST
When entering the test mode, DRAM TEST runs
automatically. And if the function are normal,the software
program version will displayed on the 7seg LED for the
few seconds, and next test starts automatically.
If the problem is found in DRAM, the following display
will appear and the test mode stop.
DJ-2000
May, 1998
*In the case of version number is 1.01.
[EFFECT BAL]
: MAX
[FORMANT / RESO]
: MIN
[PITCH / DEPTH]
: MAX
[RATE / CUTOFF]
: MIN
TEST MODE
[EFFECT BAL]
: MAX
[FORMANT / RESO]
: MIN
[PITCH / DEPTH]
: MAX
[RATE / CUTOFF]
: MIN
Содержание DJ-2000
Страница 3: ...3 ONTROLS DJ 2000...
Страница 4: ...May 1998 VIEW...
