13
Panel descriptions
D-BASS 210/115 Rear Panel
fig.01-02
1. FOOT SW Jack
You can connect a latch-type switch (optional BOSS FS-
5L) and use the switch to turn the Mute function on and
off.
* Set the foot switch Polarity setting as shown below.
fig.01-03
When you have a foot switch connected, the mute
function can be switched on with either the MUTE
switch (p. 12) on the front panel or the foot switch.
Switching either one to ON turns on the mute function.
To turn muting off, set both the MUTE switch and the
foot switch to OFF.
2. SUB OUT Jack
Use this to connect the D-BASS 210/115 with the 115X.
Connect this jack to the 115X INPUT jack.
* The volume level for this output is adjusted with the
VOLUME knob. Thus, you can also control the volume of the
115X with the D-BASS 210/115 VOLUME knob.
In this case, the volume balance between the D-BASS 210/115
and the 115X does not change.
3. LINE OUT Jack
You can connect a mixer, recorder, or other such device
here.
The output level is +4 dBu.
* The VOLUME knob has no effect on the signal from LINE
OUT. Adjust the volume on the connected device.
4. EFFECT Jacks
Use this to connect external effects processors and other
such devices.
The input/output level is +4 dBu.
SEND Jack:
Connect this jack to the external effects processor’s input
jack.
RETURN jack:
Connect this jack to the external effects processor’s
output jack.
* When connecting external effects processors, adjust the
EFFECT BLEND knob (p. 11) so it’s at an appropriate setting.
Turning the knob completely to the left puts the D-BASS into
effect bypass mode, so no effect sound is output.
1
2
3
5
6
4
PA Mixer
Tuner
Recorder
INPUT
INPUT
INPUT
OUTPUT
INPUT
INPUT
