Roland CAMM-1 PNC-1610, Руководство пользователя

Страница: 13 / 41

5
Connection
Mounting the cutting machine to the stand
Assemble the parts in the sequence in which they are numbered in the list
of included items, then install the PNC-1610. To prevent the PNC-1610
from slipping or falling off the stand, be sure to install the cap screws
(10) and washers (12) securely. When changing the installation angle, be
sure to first switch off the power to the PNC-1610. After assembly and
installation are complete, tighten the knob bolts
(6) securely.
The two enlarged areas in the figure at right show the left-hand side of the
stand. When working on the right-hand side of the stand, be sure to insert
the pins
(7) from the opposite direction of what is shown in these draw-
ings.
Use care to avoid pinching the fingers when placing the unit on the stand.
- Always use a power supply with
±
10% of the rated voltage.
- Be sure that the power is switched off when making connections.
- Check that the power supply cord and transmission input cable from the computer are firmly connected and will not
come loose during use resulting in a poor connection.
Power Cord
Power Connector
Parallel Connector
Serial Connector
* Connect to
one or the other
Parallel Interface Cable
(Sold seperately)
Serial Interface Cable
(Sold seperately)
Printer Connector
RS-232C Connector
Parallel connection
Use the parallel interface cable to connect the parallel connector on the left side of the device with the printer connector on the
host computer. Secure the connectors in place with the lock pins on each end.
Serial connection
Use the serial interface cable to connect the serial connector on the left side of the device with the RS-232C connector on the
host computer. Secure the connectors in place with the screws provided on each end.
After its power has been switched on, the device can automatically determine and store in memory the type of interface used
(and also the communication parameters, if a serial connection is used) according to the data that is downloaded from the
computer. This means that there is no need to make these settings on this product for the type of interface (or for the
communication parameters, if a serial connection is used).
If you want to change the type of interface being used, you must first turn off the power to the computer and the device, change
the cable connections, and then again switch on the power to the computer and the device. (Reconnection of the cables is not
required when changing the settings for communication conditions only)