INSTALLATION INSTRUCTIONS
59976N Rev C 10-
2017 • Questions? (800) 234-6992 • ROLAProducts.com
PAGE 9
6.
Turn the locking handle in a clockwise direction to tighten the end support to the vehicles side rails.
Fig. E
.
The handle must be firmly turned (equivalent to 4Nm or 35 in/ lbs.) to achieve a positive and tight fit. Always
turn the handle clockwise until horizontal to align the lock with the internal locking position. At the same time
the locking jaw is tightened the end support will clamp the cross bar into position. Repeat this procedure on
all end supports.
7.
If a gap exists between the bar and the rubber seal of the end support add the height adapter as shown.
Fig. F.
Position slider tab.
Fig. G
Cut outer under-cover &
slide into place.
Slide end caps in
place & lock.
Fig. E
Locking jaw firmly pressed
against the vehicle rail.
E
N
G
LI
S
H
Slide the position slider tabs outboard until they touch the back of the RBU end supports leaving no gaps.
Slide the outer under-cover into place and mark with a pencil for length, remove and cut.
Tip: Cut approx.
1/8” or 2mm longer than needed to avoid gaps.
Slide under-covers into place.
Replace the end caps and lock in place.
Fig. G
.
8.
Gap
Height Adapter
Height Adapter
Fig. F
