59680
PART No:
Acadia with Side Rails
2010-On
Fitting Instructions
CARRYING CAPACITY:
Pg 1 of 1
Your Crossbars come pre-assembled.
Place Crossbars on the
vehicle at the
recommended
positions shown along
the Roof Side Rails.
( Fig. 4)
Fig 1
Fig 3
Fig 2
75Kgs/
165 Lbs
Printed in China
Ensure that the roof side rails
are clean and free from dust
and grease.
Straps are to be extended to
allow easy mounting of the
Crossbars. (Fig 1)
Place the Crossbars onto the
vehicle’s roof side rails (note side
rails may have a position marking
on them). Gradually tighten bolts
alternating sides with the security
wrench ensuring straps are
properly engaged and even
tension is achieved. (Fig 2) There
may be the need to guide the strap
into position.
Reverse procedure to remove.
Crossbar’s locking end caps may
be removed to access the
accessory T-slot channel. (Fig 3)
Service buffer strips may be
purchased should the buffers
need to be cut around
accessories.
End Cap
Lock Barrel
Crossbar
Crossbar
REGULARLY CHECK THE TIGHTNESS OF LOCKING STRAPS.
Loads should be evenly distributed and secured
.
Check the function of all doors and sunroof before driving
.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should
therefore be driven with increased caution.
For lost Key or Security Wrench replacement or other service items call customer service:
1-800-632-3290
.
Please have lock core number or part numbers available.
Only use NON-STRETCH tie down straps.
A number of accessories for carrying special loads are available.
Ensure bars are parallel and straps are tightened against
the side rails. Perform a check by tugging on the Crossbars.
NOTICE: Crossbars can cause wind noise. Remove Crossbars when not in use.
59680N Rev A 3-20-14
Fig 4
Actual roof side rails may be different
Properly engaged
Strap
Roof Side Rail
Security
Wrench
Roof Side Rail
End Support
NOTE:
Do not over tighten bolts.
!
Extended
Position
Crossbar
Strap
End
Support
Cross bar
Slot
End Support
CAUTION!
SHARP
EDGES
Note:
Do Not Extend beyond thread of bolt.
Strap
Extended Position
700mm/ 27-
1/2” Min
350mm/ 13-
3/4”
Front of Vehicle
Front Door
Rear Door
