E. BATTERY AND ELECTROLYTE
INSTALL:
INSPECTION:
●
Install the fuse into fuse case and fasten the cap.
●
Try to pull the fuse after installation. If loose, the
●
This series uses a sealed battery so you do not have
fuse can overheat and breakdown.
to inspect electrolytes.
WARNING:
NOTICE:
●
Do not use any fuse larger than installed.
●
Absolutely do not open the lid of battery.
Doing so can cause wire melt down and fire.
●
Battery may produce flammable gas. Take care of sparks or flames
●
Use approved electrical parts from your Motofino distributor
when changing or performing maintenance on batteries.
or dealer.
●When
not used for a long time, battery may self-
●
If cannot find out the reason, deliver the motorcycle to
discharge. To prevent discharging place battery on a recharge
distributor or service center for inspection and repair.
and store in a cool place.
●
Do not use high pressured water to wash around the side cover.
If battery is stored on the motorcycle for a long period of time,
disconnect the negative terminal.
VIII. WHEN ENGINE WILL NOT START:
F. FUSE REPLACEMENT:
●
Check gasoline fuel level.
●
Make sure that safety switch is in the "on" position.
REMOVE:
●
Check the starting procedures.
●
Turn off the cap of the fuse case and take out the fuse.
●
Kick start several times
●
If fuse connection is not good, the fuse will
●
Check battery hook ups.
overheat and breakdown.
●
Check that "flooding" has not occurred.
●
Have a trained professional look at your scooter.
