11
OPERATION
The pressure in the tank is controlled by the action of the pressure switch located under the pressure switch cover
When the set maximum pressure is reached the pressure switch activates and the motor is turned off. The pressure
will then decrease as the air is used until the set minimum is reached after which the pressure switch turns the motor
on again.
The operator of the compressor should be well aware that during use of the compressor the motor will cycle (start and
stop) under the influence of the rising or falling pressure in the tank and the motor will start without any warning.
The maximum and minimum pressures are factory set and should not be altered.
You can utilize either the direct outlet and/or the regulated outlet. The pressure of the regulated outlet can be
changed by turning the control knob. Rotate the knob clockwise to increase pressure and anti-clockwise to decrease
Note:
Output fittings may differ from those shown
Turn on
Turn off
Tank gauge
Regulator gauge
Pressure regulator
Air outlet
Safety valve
