ROJEK Co.
PF 300L,°-LE, PF 350, -E
22
an example of a setting up :
needed value
22,5°
last set up value
30°
_ (1x) 30 displayes and zero (blinks);
_ (5x)
35 gets displayed;
_ (1x)
3 blinks;
_ (1x)
25 gets displayed;
_ (1x) 025 displays and zero blinks;
_ (2x)
225 displays;
_ (4x) 000225 displays and decimal point blinks;
_ (1x)
decimal point is shifting to the left and needed 000
22,5
displays.
- By pushing the pusher M (arrow underlined) the drive of tilting starts a move to a
newly input position, that is reached always from one side ( from 0° to 45°).
- The blade-tilting-drive can be stopped (during setting the blades´position) by pusher
M (underlined arrow).
- A coeval pushing the pusher M (underlined arrow) and L (arrow upward) zeroizes
the position scaler, eventually.
- In case of inputting a value besides tilting range (0°- 45°) - the drive stops at one of
limit positions by help of limit switches. It is necessary to stop a searching for this
wrong input value by a pusher with underlined arrow.
- After inputing a correct value and after pushing the pusher of drive (underlined
arrow) - you reach this needed value.
Notice : Do not manipulate with uninscribed pushers nor with a mutual
combination of them.
9.0 Machine operating and adjusting
9.1 Riving knife and fender unit adjustment
The riving knife prevents eventual
workpiece enclosure behind the saw
disk and its claps during sawing. This
could come about a back cling. The
riving knife must be mounted perma-
nently. It is adjusted by scrolling so
that its horizontal distance from the
saw disk should be 3- 8 mm and ver-
tically 2 - 3 mm.
The fender is mounted above onto
the riving knife into an "L" shaped
groove.
