Rointe SMART Touch, Руководство по быстрой настройке

Страница: 2 / 32

SMART Touch
2
INTRODUCTION
This thermostat is designed to aid in the comfort of your home by providing timed regulation of your heating system. The
thermostat is designed to receive temperature input signals from the following sensors:
1.
Air sensor located inside thermostat
2. Floor sensor installed in floor if using underfloor heating (see heater instructions for details)
The thermostat is not a safety device. In order to avoid damaging your system the correct system and floor type should be
selected during the thermostat programming process.
WARNING – Important safety note
This product uses mains voltage electricity and work should only be carried out by a qualified electrician. You should always
isolate the power supply before attempting to install or repair the thermostat. The thermostat should not be put into operation
unless you are certain that the entire heating installation complies with current general safety requirements for electrical
installations. Electrical installation to be in accordance with latest Wiring Regulations.
LOCATION
The thermostat should be installed inside a single gang electrical wall box that is at least 35mm deep. For optimal performance
the thermostat should be located in an area with good ventilation. It should not be beside a window/door, in direct sunlight or
above another heat generating device (e.g. radiator or TV). The thermostat is designed for operation between 0°C and 55°C with
relative humidity less than 80%.
EN
This is an Easy Setup guide. For full instructions please visit rointe.co.uk / rointe.ie.