EN
5
Installation And Use
1) Installing mop pads and adding water
Open the water tank plug above the
water tank (open from left to right as
shown in the picture);
Then add clean water to the
appropriate water level in a
measuring cup;
Caution
1. The cleaning performance will be reduced, if the mop pads are not correctly attached to the rotating
plates
;
2.
3.
Do not fill the water tank by putting it directly under the tap water
;
4.
Do not add other stuff in the water tank to prevent blocking the water tank
;
5.
Empty the water tank after cleaning the floor
;
Do not add water at temperature exceeding 50 °C. Adding other liquids will cause damage to the
inside of the product.
2) Adjusting the water output
Press the button to switch
to Small Water Output mode,
the “one water drop” icon on
the left lights up. This mode
is used to clean floors that
cannot get severely wet or
to reduce the water output
amount.
Press the button again to
switch to Large Water Output
mode, the “two water drops”
icon on the right lights up. This
mode is used to clean stubborn
stains or to increase the water
output amount.
Press the button once
aga i n to sw i tc h to N o
Water (or Dry) mode, the
water drop icons light off.
Caution
1.
The water drop icon lights are Off by default when the product leaves the factory. Please adjust the
water output amount by pressing the Water Output Adjusting button
;
2. If the product may be stopped using for a long time, please switch the water drop icon lights to Off by
pressing the Water Output Adjusting button to avoid malfunction
;
3. Before moving the appliance or when you need to dry mop the floor, please switch the water drop
icon lights to Off by pressing the Water Output Adjusting button.
①
②
③
With the furry side facing
outward, align the mop pad
center with the rotating plate
center, then attach the mop
pad to the rotating plate.
