
8
ROHO Sensor Ready Cushion Operation Manual
Cover Removal and Placement
Inspect the cover for damage and replace if necessary.
Refer to the label on the bottom of the cushion and to the image on the cover
to correctly orient your cushion and cover.
Keeping a cover on your cushion will help to
protect the cushion components. A cover will
also help to keep the air cells together, which
may aid in slide board transfers.
To remove the cover:
1. Remove Smart Check by ROHO if it is
attached to the cushion.
2. Unzip and remove the cover from the
cushion.
To cover the cushion:
1. Turn the cover and the cushion upside down:
- The non-skid material should face up and the zipped opening should face you.
- The air cells should face down.
2. Insert the cushion into the cover, following the instructions below.
Standard Cover Instructions
Heavy Duty Cover Instructions
- The back of the cushion should face the
zipper.
- Make sure all four corners of the
cushion extend through the corner
openings in the cover. Carefully pull the
inflation valve, the quick disconnect,
and the Yellow Rope through the
openings.
- Close the zipper completely. Turn the
cushion over so the air cells face up.
- The front of the cushion (the inflation
valve and the quick disconnect) should
face the zipper.
- Tuck the inflation valve, the quick
disconnect, and the Yellow Rope inside
the cover.
- Close the zipper completely. Turn the
cushion over so the air cells face up.
- When Smart Check by ROHO is attached
to the cushion, close the zipper as
completely as possible.
The cushion should lie flat inside the cover with the non-skid material on the bottom
and all cells covered.
The seated
figure shows
product
orientation.