5
ROHO AGILITY Back System Fixed Hardware Operation Manual
Wheelchair Compatibility
Warning: AGILITY hardware is compatible with many wheelchairs that recline, tilt, or are angularly adjustable up to and
including a back angle of 60 degrees. Beyond 60 degrees, AGILITY hardware may be damaged, the AGILITY may disconnect from your
wheelchair, and you may be vulnerable to falling and serious injury. Consult a with a clinician to determine if AGILITY hardware is
compatible with your wheelchair.
Wheelchair Cane Compatibility: Measure the diameter of your back canes.
Warning: AGILITY Fixed Hardware is NOT intended to be installed on back cane diameters < 1 in. (< 2.5 cm) without Cane
Sleeves. Doing so may result in an installation that is NOT secure. Consult with a clinician or the equipment provider to determine if
your back canes are compatible with AGILITY Fixed Hardware.
Circular back cane diameters (A):
1 in. to < 11/4 in. (2.5 cm to < 3.0 cm)
Cane Sleeves are
not required.
3/4 in. to < 1 in. (2.0 to < 2.5 cm)
Cane Sleeves are
required. See
c
ane
S
leeve
i
nStallation
.
Back Shell Hardware Installation
Note: If your AGILITY was provided without the back shell hardware installed, follow these instructions to install the hardware.
1)
Use the box end wrench to loosen and
remove the width/height adjustment
nuts. Repeat for both sides.
2)
Place the left (L) and right
(R) Fixed hardware onto
the left (L) and right (R)
width/height adjustment
plates.
Right back shell hardware
is shown.
3)
Replace the width/height
adjustment nuts.
4)
Finger-tighten the width/height
adjustment nuts.
5)
Tighten the width/height adjustment nuts with the box end wrench until snug + one-quarter turn.
Repeat for both sides.
Note: If a torque wrench is available, tighten to no more than 42 ± 2 inch-pounds (4.75 ± .25 Newton-
meters). Repeat for both sides.
R
A
A