Espresso maker R-990
EN
13
4.
According to the program of pre-heating, put the metal funnel (no coffee
powder in it) and jug in place. Brewing water per “ PRE
-
HEATING”.
5.
Press the Power switch one time, its red lamp will be illuminated, you should
press the pump control switch, maker sure the coffee/steam selector , when
there is water flowing out and close the pump, and wait for a moment, the
coffee maker begins to be heated.
6.
When the lamp in pump control switch is illuminated, it shows the heating is
finished. Pressing the pump control switch and make two cups coffee (about
2Oz). Then close the pump and wait for 5s.
7.
Press the coffee/steam selector, the indicator in the pump control switch will
be extinguished, waiting for until the indicator in the coffee/steam selector is
illuminated. Make steam for 2min by turning the steam control knob, then turn
the steam control knob to “o” position to stop making steam. Press the Power
switch for stop the unit immediately, make the descalers deposit in the unit at
least 15 minutes.
8.
Restart the unit and repeat the steps of 4-6 at least 3 times.
9.
Then press the coffee/steam selector , the lamp in pump control switch will be
illuminated, then press the pump control switch to brew until no descaler is
left.
10.
Then brew coffee (no coffee powder) with tap water in the MAX level, repeat
the steps of 4-6 for 3 times (it is unnecessary to wait for 15 minutes in step of
6), then brew until no water is left in the tank.
11.
Repeat the step of 9 at least 3 times to make sure the piping is clean.
12.
Follow the operation as below to cancel the descaling warning after finish
descaling. Hold and press the coffee switch and steam switch for 3 seconds
at the same time under the standby mode, and then their corresponding
indicators quickly blink for 3 times, which means the descaling warning is
canceled and the working cycle is zeroed.
