ASSEMBLING BLADES AND GRILLES
1.
Place the rear guard (8) from the front on to the motor unit (3). Align
grille (8) so that all four screw holes overlap and use the supplied screws to
attach it to the motor unit (3).
2.
On to the shaft (2), place the fan blades (9) with the collar facing
forward. Align the blades (9) so that the screw in the collar points above the
flat groove in the shaft (2). Hold the fan blades (9) in this position and
tighten the screw.
3.
Release all clamps along the perimeter of the front grille (10). Place
the front grille (10) against the rear grille (8) so that the rear grille (8) slides
into the hook located on the top end of the grille (10), and so that the screw
holes at the bottom of both the grille (8) & (10) overlap, see figure A1 and
A2. Secure all the clamps along the perimeter of the front grille (10) by
tilting them down towards the edge of the grilles (8) and (10). And then
screw the supplied screw with the nut into the overlapping holes in the
bottom part of the grilles (8) and (10).
Figure A1 Figure A2
