PRODUCT ASSEMBLY
BASE ASSEMBLY
- Put the round base on the flat ground
- There are 3 screws labeled on the base plate, take them
out before assembled.
- Put the whole body into the base plate
- Fasten the screws on the bottom of base plate. Do not
over-tighten the screws.
HOW TO ASSEMBLE THE FAN
- Remove the locking nut and blade cap from the motor
spindle (Fig.1)
- Place the rear guard into position. If this is done correctly,
the carry handle will be at the top (Fig.2),
- Fix the rear guard into position by replacing the locking
nut tightly by hand (Fig. 3). Do not force the locking nut.
- Press the fan blade (Fig.4) and locking the blade cap by
turning it clockwise
- Lift out all locking clips on the front guard (Fig 5).
- Place the front guard into position and secure it by
fastening the clips over the outer rim. The screw and nut
at the bottom of the guard must be tightened (Fig. 6).
-
-
-
-
(Fig.1) (Fig.2)
(Fig.3) (Fig.4)
(Fig.5) (Fig.6)
