RB-D610Q327TB48 User
’
s Manual
FEBL610Q327RB
3
・
PWR jumper pin(J1)
PWR jumper pin can switch the supply source of VDD pin of MCU.
PWR
Contents
CNE
VDD pin is connected to 13pin of CNE.
USR
VDD pin is connected to 9pin (UVDD) of CN2.
When attaching “EASE1000 V2” on the board, PWR jumper pin set to “EASE” if power supply from 13pin of CNE connector.
PWR jumper pin set to “USR” if power supply from CN1 connector.
・
VREF jumper pin(J2)
VREF jumper pin can switch the supply source of VREF pin of MCU.
VREF
Contents
VDD
VREF pin is connected to 2pin of PWR jumper pin.
USR
VREF pin is connected to 19pin (UVREF) of CN2.
VREF jumper pin set to “VDD” if power supply from VDD as same as selecting PWR jumper pin.
VREF jumper pin set to “USR” if power supply from CN2 connector.
・
SPVDD jumper pin(J3)
SPVDD jumper pin can switch the supply source of SPVDD pin of MCU.
SPVDD
Contents
VDD
SPVDD pin is connected to 2pin of PWR jumper pin.
USR
SPVDD pin is connected to 3/4pins (USPVDD) of CN2.
SPVDD jumper pin set to “VDD” if power supply from VDD as same as selecting PWR jumper pin.
SPVDD jumper pin set to “USR” if power supply from CN1 connector.
5.2. LED(P22-P24)
P22-24 pins of MCU on the RB-D610Q327TB48 allow direct LEDs drive. Enable to use LEDs connecting these pins when
the N-channel open drain output is selected. Unmount register on the board indicated by “R4-R6” when not using LEDs.
Figure 3 shows the LED circuit processing example.
Figure 3 LED circuit processing example
Register
