3
/13
© 2021 ROHM Co., Ltd.
No. 63UG134E Rev.001
February.2021
User’s Guide
BD63800MUF-EVK-001
1
Introduction
This evaluation kit (EVK) manual describes the usage of ROHM’s BD63800MUF-EVK-001 and control application. The purpose of the
EVK is to allow the test and evaluation of the stepping motor driver IC BD63800MUF-C in professional research and development
environments. This document provides guidelines to quickly setup the hardware and software for fast and easy stepping motor driver
IC performance evaluation.
•
BD63800MUF-C evaluation board [BD63800MUF-EVK-001]
•
SPI Master control board
•
USB cable (USB2.0 A-Male to B-Male)
•
BD63800MUF-C GUI control software (MS Windows)
•
USB Driver
For operation of the EVK the following additional items will be required:
•
PC with operating system Windows 10 or higher
•
Laboratory DC power supplies: 12 V(typ.)/1.5 A(min.) and 5 V/100 mA(min.)
•
Load (e.g. Bipolar DC step motor)
•
Connecting cables between DC power supply and boards
•
Clock generator: Input 5 V to 0 V clock signal for CLK pin. [Optional]
Figure 2 shows the setup boards and instruments as mentioned above. Detailed information for connection is described on section
4.1[Hardware]. For receiving the BD63800MUF-C GUI control software please get in touch with your local ROHM sales office or use
the general ROHM customer support system.
Figure 2: BD63800MUF-EVK-001 Evaluation Setup.
USB Cable
(A-male to B-male)
SPI Master
control board
