www.rohlhome.com
Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
INSTALLATION INSTRUCTIONS
Congratulations on the purchase of your Perrin & Rowe kitchen product. Correctly installed and with sensible care,
this product will give you many years of trouble free service.
The Country Kitchen Collection
Installation & User Guide
IMPORTANT INFORMATION
Before you proceed... We recommend you engage the services of a registered plumber to
install this product.
For ease of possible future servicing, we also recommend the fitting of conveniently placed
isolating valves.
In addition to the guide below it is essential that the written information overleaf is carefully
read and understood.
Preparation Check Box for Installer
Flush the plumbing system before
installing the kitchen product.
Once unpacked remove clamp plate and hose weight
ready for installation.
1
Installation
CARE & MAINTENANCE
Wipe down after use to avoid water spotting and mineral build up.
Occasional cleaning with warm soapy water, followed by a polish with a soft cloth is all that is required to keep the
plated finish in good condition.
Do not use proprietary abrasive liquids, powders, or pads to clean the faucet. Do not use any products
with ammonia bleach or limescale remover. You will damage the plated finish and void your guarantee.
BEFORE USE
• Carefully check the installation for leaks.
• If further building work is to be carried out in the vicinity, cover the product to avoid damaging the finish.
• Please ensure that the installation complies with local plumbing codes.
Base
Seal
Base Ring
Securing Clamp
Nuts
Insert hose in to
weight and secure
together with the
screw and washer
provided, using the
hex key provided.
Ensure that the
weight is fixed in
place.
Important note:
Do not overtighten
the screw.
2
Attach weight to hose
The weight can be
moved to vary the
amount of extension
required.
4
Test pull down
Box Spanner
(Included)
Before installing the product, leave a gap of 1 1/2"
minimum from the center of the work surface hole to
any walls or shelves (see image in section 5).
Insert the flexible connections through the work
surface hole Ø1.3/8" ensuring that the base ring and
rubber seal are in place between mixer and mounting
surface. Ensure the mixer is orientated correctly.
Secure mixer using the clamping plate and nut. (A
box spanner is provided). It is recommended to
install a stop value to the mains supply.
Please note: The rubber base seal is an essential
item and must be fitted.
Ensure there is ample room in the space under the work
surface for the hoses and weight to move freely. Test that the
spray head extends far enough by pulling it out.
The spray head should retract smoothly and fix back in place
comfortably.
Connect Hot & Cold water supplies. For ease of servicing it is
recommended that stop valves be fitted to water supplies. Take
care in ensuring the flexible hoses are installed without kinks or
twists.
Important note: Ensure that the hose for the spray is
securely in place and fed through the plastic hose guide. This
should prevent the spray hose from becoming twisted with the
hot and cold inlet hoses.
Ensure all connections are firmly tightened.
More
Extension
Less
Extension
19
1
/2
"
M
ax
To turn the faucet on push the lever
inwards toward the body.
5
Operation
Hot water
Cold water
3
Weight adjustment
Outer Spray
To change the flow of water from the inner jet to the
outer spray, with the water running slide the button
downwards. The spray will return to the inner jet after
turning the faucet off.
Inner Jet
1 1/2" Min.
