INSTALLATION INSTRUCTIONS
INSTRUCCIONES PARA LA INSTALACIÓN
INSTRUCTIONS D’INSTALLATION
R1062 DEDICATED DIVERTER
•
Must have both rough and trim to complete theinstallation.
•
Flush the plumbing system before installing this product.
•
Must follow dimensions supplied for installation and make sure allowance is made for finished wall material
such as tile, etc.
•
Must use with volume control when used with thermostatic valve
•
1 X 1/2”M NPT inlet
•
3 X 1/2”M NPT outlets
•
Flow is dedicated
•
May not be split into two outlets at once
•
CalGreen compliant
•
5 GPM
•
Outlets may be capped if not used
•
Min. depth is 3 3/8" from middle of the valve outlet
•
Max. depth is 5 1/2 " from middle of valve outlet (check dimensions)
•
Extension solution included in the rough package. Cut barrel and extension to size as needed.
ROUGH-IN DIMENSIONS.
1/2
" NPT
4 1/2"
2 9/16"
3 1/8"
4 3/8"
1 3/4"
MIN 3 3/8
"
MAX 5 1/2
"
3 1/2
"
5/8"
A = CUT TO DESIRED LENGTH, LEAVE 5/16” OUTSIDE THE FINISHED WALL
B = ~1/2”
REQUIRED MEASUREMENTS
NOTE: Valves
must be installed
according to
direction of flow
A
B
TOP VIEW
FINISHED WALL
2 1/2”
8" SPREAD
SPOUT CONNECTION
½” FEMALE NPT NIPPLE
A
B
Adaptors NOT needed
if used for Michael Berman
volume control
PLEASE NOTE: THE STEM IS PART OF THE CARTRIDGE. TAKE CARE TO MEASURE TWICE, CUT ONCE. IF THE STEM
IS CUT TOO SHORT, YOU MAY HAVE TO REPLACE THE CARTRIDGE. ALSO, THE ALL THREAD DOES NOT STACK. IF
CUT TO SHORT, THE ALL THREAD SLEEVE CAN BE REPLACED.
