GUI Reference
R&S
®
ZNB/ZNBT
292
User Manual 1173.9163.02 ─ 38
Start Cal Sweep
Start the calibration sweep(s) for the selected port and power calibration settings and
close the dialog. The calibration is performed as described in
Use the
"Pwr Cal Settings" to modify the calibration procedure.
Remote command:
SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect[:ACQuire]
Power Cal Dialog (Meas. Receiver)
In "Meas. Receiver" mode the "Power Cal" dialog guides you through the power cali-
bration for a particular receiver port.
"Meas. Receiver" calibrates the measurement receiver only; the reference receiver is
calibrated together with the source. To ensure accurate source signal powers, a source
power calibration is required prior to the measurement receiver calibration.
Background information
Refer to
Chapter 4.5.6.2, "Measurement Receiver Calibration"
Access:
CHANNEL > CAL > Start Cal > Power Cal... > Meas. Receiver
Port Overview
The dialog shows all receiver ports of the network analyzer. The selected port is dis-
played with the current cal power settings (see
Chapter 5.4.3.2, "Modify Cal Power
on page 334); moreover, a circuit diagram visualizes the purpose of the mea-
surement receiver calibration.
Cal Softtool
