Installation and Commissioning
R&S
®
TS7124AS
30
Instructions Handbook 1179.2948.02 ─ 01
Figure 6-5: Set of torx screws and washers, included in the rack mounting kit
1 = Large washers, small spring-lock washers and M6 x 12 screws (4 each) for fixing the metal sheet to
the chamber
2 = Grounding sockets, small thick washers and M5 x 14 screws (6 each) for fixing the metal sheet to
the rack
8. Attach the six screws, washers and grounding sockets (labeled (2) in
) to
the six outer holes in the metal rack cover sheet.
Make sure to insert the grounding sockets (2b) from the rear side of the cover
sheet, and the M5 screws and small washers (2a) from the front side. The result is
shown in detail (4) in
. Once inserted and tightened to the grounding
sockets, you cannot remove the M5 screws from the metal sheet.
Figure 6-6: Matching the screws and washers to the various holes in the metal rack cover sheet
1 = Large washers, spring-lock washers and M6 screws (4 each) for fixing the metal sheet to the
chamber
2 = Grounding sockets, small washers and M5 screws (6 each) for fixing the metal sheet to the rack
2a = M5 screw and small washer. Insert from the front side of the metal rack cover sheet
Mounting the Chamber
