Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 731 / 1088

Remote control commands
R&S
®
SMM100A
731 User Manual 1179.1341.02 ─ 05
13.16 SOURce subsystem
The
SOURce
subsystem contains the commands for configuring signals.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
SOURce<hw> [1]
●
SOURce[1] = RF output
(optional keyword)
●
LF output =
SOURce:LFOutput
(
SOURce
is optional keyword)
● Connector settings ................................................................................................ 731
● SOURce:BBIN subsystem .................................................................................... 739
● Analog modulation subsystems ............................................................................ 747
● SOURce:BB subsystem ........................................................................................767
● SOURce:CORRection subsystem .........................................................................875
● SOURce:FREQuency subsystem ......................................................................... 885
● SOURce:INPut subsystem ....................................................................................894
● SOURce:IQ subsystem .........................................................................................895
● SOURce:IQ:OUTPut subsystem ...........................................................................898
● SOURce:LFOutput subsystem ..............................................................................902
● SOURce:LIST subsystem ..................................................................................... 914
● SOURce:NOISe subsystem ..................................................................................927
● SOURce:OCCupy subsystem ...............................................................................929
● SOURce:PGEN subsystem ...................................................................................931
● SOURce:PHASe subsystem .................................................................................933
● SOURce:POWer subsystem ................................................................................. 934
● SOURce:ROSCillator subsystem ..........................................................................944
● SOURce:SWEep subsystem .................................................................................949
13.16.1 Connector settings
This section summarizes the commands of the
OUTPut
and
INPut
subsystems, nec-
essary to configure the connectors settings. Listed are the commands for configuring
the output signals and the inputs for trigger, data, and control signals.
The
...:USER<ch>:...
commands determine the global trigger threshold and input
impedance values, that affect all trigger and control signal inputs. The connector set-
tings concern to all digital modulations, the generation of waveforms or multi carrier
signals, and all digital standards.
Refer to Chapter 13.16.7, "SOURce:INPut subsystem" , on page 894 for description of
the commands for configuring the inputs for external modulation signals.
Required options
See also Chapter 11.2, "Configuring local and global connectors" , on page 527.
SOURce subsystem