Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 336 / 1088

Configuring the RF signal
R&S
®
SMM100A
336 User Manual 1179.1341.02 ─ 05
You can conveniently modify parameters like modulation settings during run-time.
Learning list mode data is not required. Impacts like temperature drift are also consid-
ered immediately.
This mode is optimized for maximum signal quality , and is useful if dwell times higher
than 2 ms are sufficient.
7.10.5 Sweep mode settings
This section lists the settings of all available sweep modes.
Access:
1. Select "RF" > "Sweep/List" > "RF Frequency Sweep"
2. Select "RF" > "Sweep/List" > "RF Level Sweep"
3. Select "RF" > "Sweep/List" > "LF Frequency Sweep"
The sweep modes use the similar parameters to be configured. Thus, the descrip-
tion comprises the settings of the three dialogs, "RF Frequency Sweep", "RF Level
Sweep" and "LF Frequency Sweep". If parameters relate to only particular modes,
they are pointed out.
The remote commands required to define these settings are described in:
●
Chapter 13.16.6, "SOURce:FREQuency subsystem" , on page 885
●
Chapter 13.16.16, "SOURce:POWer subsystem" , on page 934
●
Chapter 13.16.18, "SOURce:SWEep subsystem" , on page 949
●
Chapter 13.16.10, "SOURce:LFOutput subsystem" , on page 902
Settings
● General sweep settings .........................................................................................336
● Frequency range settings ......................................................................................341
● Level range settings ..............................................................................................343
7.10.5.1 General sweep settings
Access:
► Select, for example, "RF" > "Sweep/List" > "RF Frequency Sweep".
Varying the RF signal in list or sweep mode