Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 298 / 1088

Configuring the RF signal
R&S
®
SMM100A
298 User Manual 1179.1341.02 ─ 05
In the "RF Frequency" dialog, you can configure:
● RF frequency, incl. an offset or multiplication factor of a downstream instrument
● The step size for varying the frequency with the rotary knob.
The remote commands required to define the settings are described in
Chap-
ter 13.16.6, "SOURce:FREQuency subsystem" , on page 885.
Settings
Frequency ................................................................................................................... 298
Offset ...........................................................................................................................299
Multiplier ......................................................................................................................299
User Variation ..............................................................................................................299
└ Variation Active ............................................................................................. 299
└ Variation Step ................................................................................................299
Frequency
Sets the RF frequency.
This frequency is output at the RF connector. It does not consider an Offset or multipli-
cation factor ( Multiplier ).
See "RF frequency and level display with a downstream instrument" on page 296.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
The display has been disabled for security reasons.
See:
–
Annotation Frequency
– Annotation Amplitude
The display is disabled when:
–
List mode is running, see Chapter 7.10, "Varying the RF signal in list or sweep
mode" , on page 319.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]
on page 889
RF frequency settings