Rohde & Schwarz SMC100A, Руководство по эксплуатации

Страница: 93 / 363

Instrument Function
R&S
®
SMC100A
76 Operating Manual 1411.4060.32 ─ 04
see
​
chapter 5.3.8.1, "Automatic Level Control - ALC" , on page 124
●
Power Sensors
see
​
chapter 5.3.5, "NRP-Z Power Viewer" , on page 113
●
User Correction
see
​
chapter 5.3.8.2, "User Correction" , on page 126
The analog and external digital modulations are activated in the "Modulation" function
block:
●
Amplitude Modulation
see
​
chapter 5.4.2, "Amplitude Modulation (AM)" , on page 147
●
Frequency Modulation
see
​
chapter 5.4.3, "Frequency Modulation (FM)" , on page 149
●
Phase Modulation
see
​
chapter 5.4.4, "Phase Modulation (PhiM)" , on page 151
●
Pulse Modulation
see
​
chapter 5.4.5, "Pulse Modulation (PM)" , on page 153
The internal LF generators, the LF frequency sweep and the pulse generator are con-
figured in the "Mod Gen" function block:
●
LF Frequency Sweep
see
​
chapter 5.5.2, "LF Frequency Sweep" , on page 155
●
LF output
see
​
chapter 5.5.3, "LF Output" , on page 161
5.2 General Instrument Settings
5.2.1 Overview of General Instrument Settings
This section describes the settings which do not directly affect signal generation. Most of
these settings can only be accessed by means of menus which are opened using keys
or key combinations on the external keyboard or keys on the front panel key emulation.
The general instrument settings therefore affect various functions, such as storing instru-
ment settings using the FILE key or setting the GPIB address in the menu of the
SETUP key. The order in which the descriptions are given corresponds to the layout of
the keys on the front panel of the R&S SMC (from top left to bottom right).
5.2.2 Default Instrument Settings - Preset Key
The PRESET key calls up a defined instrument setup. All parameters and switching
states are preset (also those of inactive operating modes). The default instrument settings
provide a reproducible initial basis for all other settings.
General Instrument Settings