Rohde & Schwarz Smart Instruments UP300, Руководство по эксплуатации

Страница: 40 / 355

Unpacking the R&S UP300/350 R&S UP300/350
E-1147.2759.00 3-40 Operating Manual, 11/2007
3 Putting the R&S UP300/350 into Operation
This chapter Chapter 3 describes how to put the R&S UP300/350 into operation and
connect an external keyboard.
Further
information Chapter 2 contains an overview of the R&S UP300/350‘s control elements,
indicators, etc.
Chapter 4, “Getting started”, takes you step-by-step through a number of
simple measurements.
Chapter 7 is an in-depth description of the instrument’s interfaces.
ATTENTION
Before putting the R&S UP300/350 into operation, make the following checks:
ƒ Ensure that the ventilation holes are free of obstructions.
ƒ Ensure that there are no unsuitable signal voltages connected to the
input.
ƒ The R&S UP300/350’s outputs may not be overloaded and correct
polarity must be ensured.
The instrument may be damaged if the above checks are not performed.
3.1 Unpacking the R&S UP300/350
Recommended
procedure When you unpack the R&S UP300/350, proceed as follows:
1. Remove the R&S UP300/350 from its packaging and check that the
delivery is complete using the accessory list (
Ê 1-36).
2. Carefully check the R&S UP300/350 for any damage.
3. If there is damage, immediately contact the carrier who delivered the
instrument. Under these circumstances, it is essential to keep the box, in
which the R&S UP300/350 was transported, and the packaging material.
3.2 Setting up the Instrument
CAUTION
There is a risk of injury from sharp edges and becoming wedged
between the setting lever and the handle.
Always be careful not to injure your fingers when installing the instrument and
adjusting its handles.
Setup instructions
The R&S UP300/350 must be only assembled on a firm, level surface. The
instrument has a carrying handle which is also used for various setup options.
This handle can be moved into any position, depending on the
particular field of application.